As a South Shore commercial roof repair contractor, we clear storm-clogged drains and repair the seams and flashing water reaches first.
A South Shore commercial roof repair contractor works under Kentucky rules, even though Portsmouth, Ohio sits just across the river. Crews and suppliers coming from Ohio follow the Kentucky Building Code here.
Low-slope sections near the river collect storm debris in their drains, so clearing them is a common first repair.
Water that cannot leave the roof finds the weakest seam nearby.
Leaves, branches and silt carried by river storms pack drain strainers on low-slope sections. Water then sits around the drain, works into the nearest seam and shows up inside as a ceiling stain.
Usually Means: Drain cleared, strainer dome replaced and the seams around it probed.
Cracked domes let debris into the drain line itself.
Laps that sit in water longest open first.
Wet, crushed boards around drains leave a dip that holds water.
Packed scuppers back water up behind the edge.
Drainage repairs come first because they protect every seam on the roof.
A cleared drain with a new strainer moves storm water off before it sits against seams. That single repair takes the pressure off every lap around it.
Laps that dry out between storms hold their bond.
No standing water crushing the insulation around drains.
Work described for the Kentucky office from the start.
Drain-first repairs make up most South Shore work.
Debris cleared and broken strainer domes replaced.
Wet boards around drains replaced and the slope rebuilt.
Scuppers opened up and resealed at the edge.
Open laps near drains cleaned and patched.
Clogged drains are the usual reason. We clear them first and then check the seams the water reached.
Drainage first, then seams.
We find every drain and scupper, note standing water and probe the seams around each one.
Debris comes out, broken domes are replaced and clamping rings reset.
Wet boards around drains are replaced and the slope rebuilt so water reaches the drain.
Laps that sat in water are cleaned and patched with matching membrane.
Not in South Shore? call us or send us a message. These are the nearby Kentucky towns where we repair commercial roofs.
Floodwall flat roofs and downtown parapets
Dew-heavy mornings and dry-surface patch timing
River wind at corners, coping and edge metal
Rooftop unit swaps and canopy roof repairs
Hail checks with dated photos of each roof part
Rusting farm and shop metal roofs
Confirming the right city office before repairs
Rooftop unit shutdowns for curb repairs
Structural deck and purlin repairs with state permits
State-permit repairs and drains cleared before seams
Code and drains come up most.
Kentucky rules. Even with Portsmouth across the river, a South Shore building falls under the Kentucky Building Code. Permit questions go to South Shore city hall or the county judge-executive's office, and the inspector is the Greenup County local or state inspector.
Yes, working under the Kentucky Building Code and the local office's rules for the job.
No, as long as the work meets the Kentucky Building Code and the manufacturer's instructions for the roof system. Suppliers in Portsmouth or Ashland carry the same membranes and metal. What matters is matching the patch material to what is already on the roof.
Spring, fall and after any strong storm. Roofs near the river and trees fill faster.
Water that sits around a clogged or high drain works into the nearest seam. Clearing the drain and patching that seam fixes both.
Water piles up around the drain, works into the nearest seams and soaks the insulation around the bowl. The wet boards crush and leave a dip that holds more water every storm. Clearing the drain early stops that cycle before the boards have to be replaced.
Yes, when it is local. Wet boards around the drain are cut out and replaced, and a tapered sump is built so water flows into the bowl. A drain set higher than the roof gets a retrofit insert. Ponding across large areas needs tapered insulation, which goes with a bigger project.
An overflow scupper is an opening through the parapet set slightly above the roof surface. If the main drain clogs, water leaves through the scupper before it rises high enough to reach flashing or coping joints. Roofs with parapets and only one or two drains benefit most from one.
The cage over a roof drain that keeps debris out of the line. Cracked ones get replaced so the drain stays open.
Check them after strong storms and when leaves drop in the fall. Pull debris off the strainer dome by hand, and replace any dome that is cracked or missing. If a drain still holds water after it is cleared, the line or the slope around it needs a closer look.
Yes. Metal shops and warehouses get screw, lap and panel repairs, and river humidity ages washers and end laps here too. Gutters on metal buildings get the same storm clearing as drains on flat roofs, since packed gutters back water under the panel ends.
Interior stains with the date, standing water on the roof if you can see it safely, and any drain or gutter you know is clogged. Note the weather when the leak showed up. Those details point us to the right drain and seam before we climb up.
Tell us where water stands after rain. We will clear the drains and repair the seams it reached.
